This section displays information about the power supplies.
The following entries may be displayed on supported servers:
Location displays the bay where the power supply is located.
Status displays the status of the power supply. The following values are possible:
No Error
General Failure
Bist Failure
Fan Failure
Temperature Failure
Interlock Open
EPROM Failed
VREF Failed
DAC Failed
RAM Test Failed
Voltage Channel Failed
Orring Diode Failed
Brownout
Give Up On Startup
If the power supply is absent, the status is shown as "Not Applicable"
Serial Number displays the serial number of the power supply. This information can be used for identification purposes.
Firmware Revision displays the firmware revision of the power supply.
Present: Represents whether the Power Supply is present in the chassis.
Used Capacity (%): Represents the current Power Supply capacity which is a percentage of its maximum capacity.
Used Capacity (W): Represents the current Power Supply capacity in Watts.
Max Capacity: Represents the maximum capacity of the Power Supply in watts.
Model: Represents the Power Supply Model name.
Voltage: Represents the Input Main Voltage of the Power Supply in Volts.
Redundant: Represents the redundancy state of the power supply.
The following values are possible:
Redundant
Not Redundant
Unknown
If the power supply is absent, this field will be shown as "Not Applicable"
Hot Pluggable: Represents if the power supply is capable of being removed and/or inserted while the system is in an operational state.
The following values are possible:
Hot Plug
Not Hot Plug
Unknown
If the power supply is absent, this field will be shown as "Not Applicable"
The following entries may be displayed on some servers if the above information is not displayed:
Installed - The following values are possible:
Not Applicable
Not Supported
No
Yes
Status displays the status of the power supply. The following values are possible:
Not Applicable
Ok
Degraded
Failed
Operation - The following values are possible:
Not Applicable
Fault Tolerant