NEW OS/2 INSTALLATIONS:  ****************************************************

To install the AL-7000 AL7000.ADD OS/2 2.x driver, you will need to copy the
AL7000.ADD driver file to a copy of the IBM OS/2 diskette labeled "DISK 1".  
If there is not enough free space on the floppy, you will need to delete some  
other .ADD driver from the diskette (one that you will not need for this 
installation).  You will then need to modify the CONFIG.SYS on DISK 1 to load 
the driver.  A sample CONFIG.SYS called CONFIG.OS2 has been zipped in with 
this file to show how the driver should be loaded.

You may add support for LUNs by adding the "/et" to the al7000.add load line 
in config.sys.

** This version of the driver also supports Scatter Gather.

** This driver supports SCSI tape and has been tested with NovaStor's
   NovaBack 2.02b for OS/2 2.x.


Some SCSI devices can cause system failures when initiating synchronous data
transfers.  Setting the device to "async" or "sync initiated by host" will 
usually resolve this problem.

UPDATING A PREVIOUS OS/2 INSTALLATION:  *************************************

In the sample CONFIG.OS2, there are several lines highlited by REM statements.
Just add the lines that apply to your installation.  All installations will 
need to load al7000.add and os2scsi.dmd.  If you will be using SCSI hard 
drives, you also need to load os2dasd.dmd.  If you will be using CD-ROM 
drives, you also need to load os2cdrom.dmd, vcdrom.sys and ifs=cdfs.ifs.




