IBM ISA CD-ROM installation procedure    7/20/94

       File:OSDIISCD.fax

       TITLE:  IBM ISA CD-ROM INSTALLATION FOR OS/2 2.1

       To properly install this drive you will need the following:

       1. The switch settings on the interface card.  Refer to
       your CD-ROM manual.  2. The Diskette with the ISACDOS2.ADD
       driver.  3. The OS/2 diskettes or the CD-ROM install
       package.

       FOR INSTALLATION OF OS/2 2.1 FROM THE IBM ISA CD-ROM
       --------------------------------------------------------------

       1. Make a diskcopy of OS/2 DISK1.

       2. Edit the CONFIG.SYS and add the device driver line.
       BASEDEV=ISACDOS2.ADD /M:xxx Where xxx is the hex address
       set on the switches.

       3. Start the installation.

       SUPPORT FOR THE IBM ISA CD-ROM AFTER OS/2 IS INSTALLED
       --------------------------------------------------------------

       1. Open the OS/2 SYSTEM ICON.

       2. Open COMMAND PROMPTS.

       3. Open OS/2 WINDOW.

       4. Type E CONFIG.SYS.

       5. Add the line:  BASEDEV=ISACDOS2.ADD /M:xxx Where xxx is
       the hex address set on the switches.

       6. Save and exit.

       7. Type exit

       8. Close COMMAND PROMPTS.

       9. Select SYSTEM SETUP.

       10.  Select SELECTIVE INSTALL.
12/31/99