OSMKPEN - SYS1059 ERROR MESSAGE WHEN USING PEN FOR OS/2 WARP
10/20/94

================================================================
SYS1059 ERROR MESSAGE WHEN USING PEN FOR OS/2 WARP
================================================================

Please Read Entire Document for Full Explanation of Procedures
----------------------------------------------------------------


SYMPTOM:
  Receiving a SYS1059 Error Message.

RESOLUTION:
  The system cannot run the specified program.  You must
  apply a fix to the Pen installation program.


PROCEDURE:
  1.  Install the PATCH utilities:

      A.  Select OS/2 System.

      B.  Select System Setup.

      C.  Select Selective Install.

      D.  Select OK on the System Configuration window.

      E.  Select Serviceability and Diagnostics Aids.

      F.  Select Install from the OS/2 Setup and
          Installation window and follow the instructions
          on the screen.


  2. There are two methods for applying the fix for the Pen for
     OS/2 installation program.  Select the method for your
     situation.

      Method 1:  Reinstalling Pen for OS/2:

        1.  Copy the PEN.DAT file that is located in the
            \DISK10 directory where Pen for OS/2 installed.

        2.  Change to the drive and directory where Pen for OS/2
            installed.  At an OS/2 command prompt, type:

                      PATCH PEN.DAT /A   and press Enter.

        3.  Install Pen for OS/2.


      Method 2:  Installing Pen for OS/2 for the first time:

        1.  Copy the PEN.DAT file that is located in the
            \DISK10 directory on the OS/2 CD-ROM, to the
            Pen for OS/2 Diskette 1.

        2.  Insert the Pen for OS/2 Diskette 1 into drive A.

        3.  From an OS/2 command prompt, go to drive A,
            and type:

                      PATCH PEN.DAT /A   and press Enter.


        NOTE:  A message appears confirming that the fix
               is applied.

        4.  Install Pen for OS/2.